Hardwood Floor Refinishing & Installation in Smyrna, GA

Almost certainly, if the rest of the house has original oak. Smyrna's 1950s and '60s ranches were nearly all built with hardwood as the standard flooring, and carpet was usually installed straight over it rather than replacing it. We can check with a small pull test in a closet corner before you commit to tearing the whole room apart.

Yes, this comes up constantly in that part of Smyrna. We coordinate scheduling around HOA-mandated work hours and shared-wall noise concerns as a matter of course, and we are used to tighter logistics, limited parking, narrow stairwells, reserved elevator windows, that a lot of these newer townhome communities require.

It changes the installation method more than the wood options. On a slab, solid nail-down hardwood generally is not an option without added structure, so we typically recommend engineered hardwood glued or floated down instead. Refinishing existing solid hardwood that is already on the slab is a separate question, and usually fine as long as the wood is not split from moisture.

We use dustless sanding equipment that captures the bulk of it at the source, which matters even more in a townhome than a standalone house since there is less separation between rooms and, in some layouts, shared HVAC returns. We also seal off adjoining rooms and stairwells before sanding starts.

It depends on how many times it has already been sanded, which we can usually tell by checking board thickness at a vent or threshold. A lot of 1950s and '60s Smyrna ranches still have plenty of wood left because they were only refinished once or twice, but we always check before recommending a full sand.

Most of what has gone into Smyrna's newer construction over the last decade is engineered hardwood with a factory finish, and it is usually too soon for a full refinish. A screen and recoat is more likely what is needed if it is looking dull, though heavy traffic near entries can wear through even a newer finish.