Call Now Text24/7 Bookonline Free Estimate
Book a Free Estimate
Freshly sanded oak hardwood floor in a living room with a fireplace

Kennesaw, GA · Serving Cobb County

Hardwood Floor Installation & Refinishing in Kennesaw, GA

Featured Kennesaw job: red oak installed and stained Provincial in a Kennesaw home. Watch it below.

Get a free estimate

Tell us where you are and we’ll call to set a time. No obligation.

Enter your name.

Enter a valid phone number.

Enter a valid email address.

Enter the address of the job.

Or call 470-826-3581 · Open 24/7

Thanks — we’ve got it.

We’ll call or text to set a time — usually the same business day. If you need us sooner, call 470-826-3581.

Hardwood Floor Installation in Kennesaw, GA

Kennesaw is a city of fairly new houses. The U.S. Census Bureau’s American Community Survey (2020–2024 five-year estimates, table B25036) counts about 8,750 owner-occupied homes in the city, and nearly nine in ten were built in 1980 or later. Roughly two in three date from 1990 through 2009. These are survey estimates, a rough picture rather than an exact count.

Homes from those years are often two-story plans with carpet in the bedrooms and on the stairs. If that sounds like yours, here is how hardwood floor installation in Kennesaw usually goes with us.

What we find under the carpet

In a two-story home with a basement or crawl space, the main-level subfloor is usually plywood or OSB over wood joists. That is what solid hardwood is nailed to, so solid nail-down often works. We take up the carpet, pad, tack strips and staples, then check the subfloor for moisture, squeaks and level. Low spots get leveled, loose sheets get fastened, and damaged sections get replaced before any wood goes in.

Slab homes

Some homes sit on a concrete slab instead of a wood subfloor. Solid hardwood generally can’t go straight over concrete. On a slab we moisture-test first, then talk through engineered hardwood, which can be glued down or floated.

Basements and lower levels

Basement and lower-level rooms get the same moisture check. Below grade, engineered hardwood, luxury vinyl plank (LVP) or laminate is often a better fit than solid wood. We tell you which suits the room once we have measured it. Closer to Lake Allatoona, our LVP installation in Acworth page covers the same moisture and subfloor checks.

Stairs in two-story plans

In a two-story home the stairs are part of the job, not an add-on. Treads, risers and transitions are cut and matched to the new floor so the stairs read as one continuous floor with the rooms above and below. They go into the written estimate from the start. See stair renovation for how we handle treads, risers and railings.

Solid or engineered for a Kennesaw home

Over a plywood or OSB subfloor on the main level, solid oak nailed down is usually the first choice, and it can be sanded and refinished again years from now. On a slab, in a basement or anywhere moisture readings run high, engineered hardwood holds up better because its layered core moves less. We walk you through species, plank width and finish at the estimate, then recommend the product that fits each room rather than one answer for the whole house.

Acclimation and installation day

Wood is delivered ahead of time so it can adjust to your home’s temperature and humidity, and we check moisture in both the boards and the subfloor before the first row goes in. On installation day we protect the rooms we are not working in, remove the old flooring and haul it away, lay the new floor, and fit transitions, baseboard and quarter round so the finished floor meets doors, tile and stairs cleanly.

How a Kennesaw install works

1. Free in-home estimate: we measure, look under the carpet where we can, and leave a written estimate. 2. Material and scheduling: we order the wood and set your start date. 3. Prep: removal, subfloor repair and leveling. 4. Installation and stairs. 5. Clean-up and a walkthrough with you. Questions first? Call 470-826-3581 or see hardwood floor installation.

If a leak damaged the floor first, we document and repair the damage while your homeowner’s policy decides coverage, and we respond the same business day.

If there is already hardwood

When the boards under the carpet or in the main living area are sound, refinishing can make more sense than replacing them: we sand, stain and finish, or screen and recoat when the floor only needs a fresh topcoat. See hardwood floor refinishing in Kennesaw, or refinish or replace hardwood floors if you are weighing both.

Source: U.S. Census Bureau, American Community Survey 5-year estimates 2020–2024, table B25036 (Tenure by Year Structure Built), Kennesaw city, GA.

Hardwood Floor Refinishing in Kennesaw

A floor that looks worn does not always need the same fix. In Kennesaw we start by working out whether the finish or the wood has given out, because that decides the job.

Full sand and refinish

A full sand takes the floor down to bare wood. We sand with dust-contained planetary sanders (see dustless planetary sanding). Then we stain it if you want a new color and apply fresh finish. It is the right job when the finish has worn through to bare wood, when scratches or stains are in the wood itself, or when you want a different color. If you are choosing a color, the Provincial stain on red oak in the featured Kennesaw job is one example of a rich, warm look. Our hardwood floor refinishing page covers the whole process.

Screen and recoat

A screen and recoat keeps the stain and the wood as they are. We abrade the old finish, clean the floor and put a fresh coat over it. It suits a floor that looks dull and scratched on the surface but is still sound underneath. It cannot change the color or take out scratches that go into the wood. Read about screen and recoat, or compare it with full refinishing.

A Kennesaw example

On one Kennesaw job, the homeowner wanted her floors to look new again. We offered a screen and recoat instead of a full sand, with a deep-clean scrubber added so all the grit and grime already on the floor was removed first. The results came close to what sanding would have given her. Apart from a few gouges, the floors came out practically perfect. You can watch the job under Recent Kennesaw Jobs.

Refinishing floors in Kennesaw homes

Many Kennesaw houses were built in the 1980s–2000s, and their floors are not all alike. Some are red oak that was stained and finished on site, as with the Provincial red oak install on this page. Others are prefinished builder-grade boards, which arrive with a factory finish and beveled edges. We plan those differently, checking how much wood is left and how worn the surface is before choosing between a sand and a recoat.

On engineered floors we check the wear layer before any sanding; see engineered hardwood for how the layers work. Stair treads can be refinished to match the floors; see stair refinishing. If you want the steps in order, here is how a full refinish works.

Screen and recoat or full sand?

The choice comes down to what the floor needs. A screen, deep clean and recoat abrades the old finish, runs a deep-clean scrubber over the floor to lift the grit and grime that has built up, and puts a fresh coat of finish on top. The stain and the wood stay as they are, so it fits a floor that looks dull and scratched on the surface but is still sound underneath. On the Kennesaw job on video, that route gave almost the same result as sanding, apart from a few gouges. A full sand is the better call when scratches or stains are in the wood, when the finish has worn through to bare wood, or when you want a new color. See screen and recoat for how the service works.

We look at your floor in person and tell you which job fits before we quote either.

Recent Kennesaw Jobs

March 2023: screen, deep clean and recoat. A Kennesaw homeowner wanted her floors to look new again. We offered screen and recoat, with a deep-clean scrubber added to remove the grit and grime, as an alternative to full sanding. We can sand a floor and make it look new, but this process gets almost the same results, and on this job the floors came out practically perfect apart from a few gouges. See screen and recoat.

January 2023: red oak installation. Red oak installed and stained Provincial with oil-modified polyurethane, covered in the featured job above.

Screen, Deep Clean and Recoat Service, Kennesaw, GA Watch on YouTube ↗

Those two jobs point in two directions: new hardwood where there was none, and a refresh for a floor that is already there. If yours is already hardwood and only looks dull, compare screen and recoat with full refinishing before you decide.

Kennesaw Hardwood Floor Projects

Real Kennesaw jobs, each from a video we filmed on site. Details come from our own write-up of each job.

Red oak installation, Provincial stain · Kennesaw

Video posted January 2023

Service
New hardwood installation
Species & grade
Red oak
Stain
Provincial
Finish
Oil-modified polyurethane

Red oak floors installed in a Kennesaw home and finished with Provincial stain and oil-modified polyurethane. Provincial is a warm color that brings out the natural variation in the grain and knots of red oak.

Stained red oak stair treads, newel post and floor, hardwood installation in Kennesaw, GA Close-up of red oak floor grain with Provincial stain, hardwood installation in Kennesaw, GA

Screen, deep clean and recoat · Kennesaw

Video posted March 2023

Service
Screen, deep clean and recoat
Problem solved
A homeowner wanted her floors to look new again. Screen and recoat, with a deep-clean scrubber to remove grit and grime, was offered as an alternative to full sanding.

A Kennesaw homeowner wanted her floors to look new again. Screen and recoat with a deep-clean scrubber got almost the same result as full sanding, apart from a few gouges.

Deep-clean floor scrubber on a hardwood floor, screen and recoat in Kennesaw, GA

Water-Damaged Hardwood Floor Repair in Kennesaw, GA

Water damage repair in Kennesaw

Cupped or buckled floors after a leak? We repair, replace and refinish matching boards and document the damage. Your homeowner's policy decides coverage. See water-damaged hardwood floor repair.

Before any water damage floor repair in Kennesaw starts, we work out how wet the floor got and how long it stayed that way, because that sets every decision after it. Our water-damaged hardwood floor repair page covers the whole process; below is how it works on a Kennesaw call.

What cupped, crowned and buckled boards mean

The shape of a board tells us how the water got in. A cupped board has raised edges and a lower middle, which means it was wetter underneath than on top. A crowned board sits high in the middle and usually means a cupped floor was sanded before it finished drying. A buckled board has lifted off the subfloor, and buckled boards usually get replaced.

Moisture readings come before sanding

We take moisture readings on the boards and on the subfloor before any sanding. Cupped boards often settle once the wood and the subfloor return to normal moisture, which can take weeks, not days, so we decide on the readings, not on how the floor looks that week. If a crawlspace is still feeding moisture to the floor, we will not sell you a full sand on top of it.

Spot repair, refinish or replace

A water-damaged floor ends one of three ways. Spot repair means cutting out the bad boards and blending the color. Refinish fits a floor that is mostly sound where the finish failed. Replacing is for boards whose wear layer or core will not take another sand. When the damage is in one area, we lace in new boards of the same species and width to match the existing floor, then sand and refinish the repair with the floor around it so it does not show as a patch.

In a recent water-damage repair on video, only the areas the water had reached were replaced. New #1 grade red oak was laced in to match the floors already there, and new plywood subflooring went down first where the floor ran over concrete.

A recent water-damage repair: new red oak laced in Video posted April 2025 Watch on YouTube ↗

What to do before we arrive

Stop the leak, pull rugs and run a dehumidifier if you have one. Do not run a rental sander over cupped boards hoping they flatten. Then call or text 470-826-3581 with photos, which rooms got wet and how long ago, and we will tell you whether it is dry-and-watch, spot repair, full sand or replace before we book the week.

What we document, and who decides coverage

We document and repair. Your homeowner's policy decides coverage. You get an itemized written estimate with photos and moisture readings, so the damage and the repair are on record. We pull base when we need to see the edge. Call or text, and we respond the same business day.

Kennesaw Hardwood Flooring Questions

Generally, no. Solid hardwood is made to be nailed or stapled to a wood subfloor, so it isn't the right product directly over concrete. On a slab we moisture-test the concrete first, then talk through engineered hardwood, which can be glued down or floated. We confirm what your house is built on at the on-site measure, so nobody is guessing from the street.

What Our Customers Say

  • “The Hardwood Guys are amazing! They refinished and installed new hardwood floors in my house in December, and we could not be happier with the result! They are very professional and easy to work with!”

    Murphy M.

10,000 jobs completed in Georgia

Nearby Towns We Serve

We are based in Woodstock, GA 30189, and we work across Cobb County. Next door to Kennesaw, see hardwood flooring in Acworth and hardwood flooring in Marietta, including hardwood flooring in East Cobb. If you are planning a new floor rather than a refinish, we install in those towns too: read about new hardwood floors in Acworth and hardwood installation in Marietta. Our home base has its own page too: hardwood flooring in Woodstock. Every town we serve is on areas we serve.

Ready to Get Started in Kennesaw?

Call, text or book online. We respond the same business day, estimates are free, and our work carries a 1-year warranty on installs & full refinishes.

Financing available — up to $100,000, with interest-free options from $30/mo. Subject to approval.

Get Your Free Estimate

Call 470-826-3581 or request a free estimate online. We serve Kennesaw Mountain, Town Center, and all of Cobb County, and we’re open 24/7.

Enter your name.

We'll call to confirm your appointment.

Enter a valid phone number.

Enter a valid email address.

Enter your address or city.

Choose a service type.

We’re open 24/7. Call or text anytime; our scheduling assistant can book your estimate on the spot. No spam, no third-party sharing.

1-year warranty on installs & full refinishes · See the warranty

Thanks — We'll Be In Touch

A member of The Hardwood Guys team will call or text you to schedule your free on-site estimate. We schedule 24/7.